User manual

30 GR-UT699 Development Board

User Manual

4 INTERFACES AND CONFIGURATION

4.1 List of Front/Back Panel Connectors

Name Function Type Description

J1 UART-1 D9-S (Female) Connections for Serial UART-1 (RS232)

J2 ETHERNET RJ45 10/100Mbit/s Ethernet Connector

J3 JTAG 2x7pin 2mm header JTAG signal interface

J4A upper CANBUS-1 Dual D9-P (male) Connections for CANBUS-1 interface

J4B lower CANBUS-0 Dual D9-P (male) Connections for CANBUS-0 interface

J5 SPW-0 MDM9-S (female) LVDS connections for Spacewire Interface-0

J6 SPW-1 MDM9-S (female) LVDS connections for Spacewire Interface-1

J7 SPW-2 MDM9-S (female) LVDS connections for Spacewire Interface-2

J8 SPW-3 MDM9-S (female) LVDS connections for Spacewire Interface-3

J9 MEM I/O AMP 5177984-5 Memory I/O connector -120 pin 0.8mm pitch

J10 GPIO[15..0] 34 pin 0.1” Header Pin connections for PIO signals 0 to 15

J11 GEN I/O AMP 5177984-2 General I/O connector – 80 pin 0.8mm pitch

J12 DSU-SERIAL USB-MINI-AB Debug Support Unit serial I/F via on-board USB converter

J13 POWER-IN 2.1mm center +ve +5V DC power input connector

J14 POWER-IN' Mate-N-Lok 4pin Alternative power input for 4 pin IDE style connector

J15 SDRAM SODIMM SDRAM memory interface for SODIMM module

J16 SPW_CLK SMA SPW Clock Monitor or Injection

J17 PROC_CLK SMA Processor Clock Monitor or Injection

CPCI-J1 CPCI CPCI Type A CPCI connector

CPCI-J2 CPCI CPCI Type B CPCI connector

Table 4-1: List of Connectors