Operating instructions

GENERAL INFORMATION
1-19
PMRTEST Software (Option 14)
USER DEFINED PMR for FM radios
EDACSTM Radio Test Software (Option
15)
Provides Auto/Manual test capability for EDACS™ radios. Up to
four user-defined variants can be created and stored, each with
up to 24 spot-channel frequencies
EDACSTM Repeater Test Software (Option
16)
Provides Auto/Manual test capability for EDACS™ repeaters. Up
to four user defined variants can be created and stored, each with
up to 24 spot-channel frequencies. A data logging facility is also
available to continuously decode and display data messages from
the repeater under test.
EDACS is an Ericsson GE registered trademark.
LTR Trunking Test Software (Option 18)
Provides Auto/Manual test capability for LTR Trunked radios
Pocsag Decode (Option 22) Allows off-air decoding of POCSAG messages. Can decode a
message as it is received, or decoding can be triggered from a
user-selectable RIC code or fixed message pattern.
Bit Rate
Automatically decodes any standard bit rate up to 4800 bit/s.
Numeric and Alphanumeric decoding is provided.
Number of received errors is displayed.
CCITT (Option 23) Allows a CCITT filter to be inserted into either the demodulated
audio path or the audio input path
C-MESSAGE (Option 24) Allows a CMESS filter to be inserted into either the demodulated
audio path or the audio input path
Avionics (Option 25) The Avionics Systems provides amplitude modulated signals
suitable for testing ILS, VOR, Marker Beacons and SELCAL
Full details of the Avionics features can be found in the Option 25
data sheet , part number 46891/213
Tone Remote Option 26) Provides configuration screens and generation of Tone Remote
control signals.
Plus 2 Distortion Notch Filters board
(Option 29)
The standard instrument is supplied with a 1 kHz notch for
Distortion and SINAD measurements. This option allows the user
to carry out Distortion and SINAD measurements at two additional
frequencies. The two additional notch frequencies can be
anywhere in the band 50 Hz to 20 kHz and must be stipulated at
the time of ordering.
Bail arm and front panel stowage cover
(Option 30)
Provides a bail arm carrying handle and front panel cover and
storage area. The bail arm will also provide additional viewing
angles when mounted on a bench.
IF Output Capability (Option 31) Allows access to the IF signal from the rear of the Instrument.
(Note: Incorporation of this option replaces the standard demod
out capability.)