Operating instructions

GENERAL INFORMATION
1-18
Parallel Interface (Option 4) Allows direct connection of a parallel printer. Additionally
provides 4 software programmable output lines.
Printer port
Connector 25 way female D-type
Printers supported 75,100,150 dots per inch laser printers
FX80, FX100 Epson format.
Accessory port
Connector 9 way female D-type
Outputs 4 independently programmable output lines, each one
configurable as a logic line or as a relay contact closure.
+5V supply available.
GPIB (Option 5) For remote control of the Service Monitor.
Capability
Complies with the following subsets defined by IEEE488:-
SH1, AH1, T6, L4, SR1, RL1, E1, DC1, DT0
Memory Card Drive and Real Time Clock
(Option 6)
The memory card facility allows the storage of results, set-ups,
screen dumps and user programs. Meets PCMCIA 2 standard.
Allows the current date and time to be stored with results to the
memory card and/or printed with a screen dump.
SSB Demodulator (Option 8) The SSB demodulator allows signals to be demodulated either
via the internal loudspeaker or via the accessory socket.
Provides demodulation of SSB signals (upper and lower
sideband.)
Frequency range 400 kHz to 1 GHz
AF demodulation range 10 Hz to 15 kHz
Distortion Typically less than 3% at 1 kHz (300 Hz to 3.4 kHz)
Detection range
2 μV to 150 W
Features Automatic detection of USB or LSB.
BFO can be used for tuning of carrier for AM and FM radios.
Occupied Bandwidth (Option 9) Calculates the bandwidth of a signal displayed on the spectrum
analyzer.
Frequency range 1 MHz to 1 GHz
Displayed resolution 3 digits
Accuracy 20%
Bandwidth measurement range 3 kHz minimum
Ratio range 90% to 99%, selectable in 0.1% steps
NMT Cellular Software (Option 10)
NMT 450 NMT 900
Benelux NMTF
Austria Spain
Malaysia Indonesia
Saudi 1 Saudi 2
Thailand Oman
Tunisia Hungary
Poland Russia
Czech Bulgaria
Slovenia Turkey
USER DEFINED NMT
AMPS Cellular Software (Option 11)
E-AMPS
N-AMPS
USER DEFINED AMPS
TACS Cellular Software (Option 12)
E-TACS TACS 2 C-TACS I
C-TACS II J-TACS N-TACS
USER DEFINED TACS
MPT 1327 Trunking Software (Option 13)
BAND III JRC
UK WATER HONG KONG
AUTONET AMT
MADEIRA NL-TRAXIS
NZ MPT1327 PH-INDO
USER DEFINED MPT