Operating instructions

LOCAL OPERATION
3-92
Recalling Results
When 'Results' are recalled, the RESULTS SCREEN is displayed. The test results are shown
against each of the parameter headings. Results of tests made when in the Dx TEST mode are
shown with the RECEIVER TEST results in the top half of the display and the TRANSMITTER
TEST results in the bottom half.
Storing
Storing settings
To store settings, make sure that all the parameters, selections, bar chart ranges and other settings,
relevant to the intended work, are set as required. Then proceed as follows:-
Press the orange [MEM] key and the STORE/RECALL screen will be displayed. Ignore
the flashing inverse video message.
Press the [Store Setting] key, which will cause the flashing inverse video message to
change to, 'Store Settings To Store No'.
Key in the two digit address of the required empty or unprotected location. Any data
already contained in the location will be overwritten.
The location address list will show the contents of the location as 'Settings'.
A unique title can be attached to the store location. See 'Titling store locations' later.
DISPLAY HOLD STORE
Storing results
Results obtained using the Tx, Rx, Dx, and AF test modes can be stored. For this, the memory is
accessed using the [DISPLAY HOLD] key.
To store test results, make the required test, and when the display shows the results to be stored,
proceed as follows:-
Press the [DISPLAY HOLD] key. The current soft key menu will be replaced to show
two keys, [Print] and [Store].
Press the [Store] key which will cause the DISPLAY HOLD STORE screen to be
displayed, with a flashing inverse video message, 'Store Results To Store No.'.
Key in the two digit address of the required empty or unprotected location. Any data
already contained in the location will be overwritten.
The location address list will show the contents of the location as 'Results'.
A unique title can be attached to the store location. See 'Titling store locations' later.
Other memory functions
Other memory functions can be carried out from either the STORE/RECALL or
DISPLAY HOLD STORE screen and menu.
Protecting store contents
The contents of any store location can be protected from being over-written or deleted.
To protect a store location, Proceed as follows:-
Press the [Protect Store] key. The inverse video message, 'Protect Store No.' is
displayed.
Key in the two digit address of the location to be protected, using the data entry keys. A
'P' will be shown against the location address in the list.
Any attempt to over-write or delete the contents of the location will cause the message
'***ERROR Store protected ***' to be displayed momentarily.
To remove the protection from a location, use the same procedure used to protect the location.
The 'P' will be removed from the location address.