Operating instructions

LOCAL OPERATION
3-82 46882-311D
Stores, settings/results
Overview
A section of the non-volatile RAM in the Service Monitor is designated as a user store for
instrument settings and results. ’Power Down’ and ’Factory Pre-set’ settings are also held in this
area of memory.
The memory card option extends the ’User store’ facility, by providing additional memory and by
allowing screen bitmaps, ’SYSTEM’ settings, ’SYSTEM’ results and ’SYSTEM User Defined’ test
programs to be stored. A ’Print Store’ function allows most types of data stored on memory cards
to be printed without being recalled to the Service Monitor display.
The use of memory cards is described later under ’Memory cards’.
There are two routes through which the user memory can be accessed, depending on the action to
be performed.
To recall data from memory or to store settings, press the orange [MEM] key. This will
display the STORE/RECALL screen and menu.
To store test results or bit-maps of test screens, first press the [DISPLAY HOLD] key.
The soft key menu will change to show a [Print] key and a [Store] key. Pressing the
store key will display the DISPLAY HOLD STORE screen and menu.
STORE/RECALL
To store settings or to recall data from memory proceed as follows:-
Press the orange [MEM] key. The STORE/RECALL screen and menu is displayed. A
message, ’Recall from Store No.’ is shown, flashing in inverse video.
A sub-heading ’INTERNAL STORE’ is shown above a list of the store locations, with
addresses from 00 to 09. A line of details relating to each store is shown against each
address.
Store location 00 is followed by the information;
’P Settings Power Down Store’.
This location holds the settings of the Service Monitor when power was last switched off.
The ’P’ shows that the data is protected, it cannot be over-written or deleted.
’Settings’ shows that the data is a set of instrument settings.
’Power Down Store’ is a title identifying the contents.
Similarly store location 01 contains the factory default settings.
Recalling
To recall the contents of a store location, proceed as follows:-
Press the [Recall] key to display the inverse video message, ’Recall Store No.’ if it is not
already displayed.
Key in the two digit address of the location, using the data entry keys.
Recalling Settings
Entering ’00’ or ’01’ will recall the settings described above.
When ’Settings’ are recalled, the Service Monitor will set to the mode which was current when
the settings were saved.
Take care after recalling ’settings’, as selections such as RF IN/OUT [SELECT], incremental
settings and bar chart ranges are included.
The addressing procedure of all memory functions is similar. The flashing, inverse video
message describes the action that will happen when a location address is entered, and
requests a two digit store address. The first digit entered appears beside the message, but
the second digit of the address implements the action.