Use and Care Manual

6
OPERATING INSTRUCTIONS contd. :
NOTICE
• Add water before starting the COOLER/HUMIDIFIER mode. Turn the water tank knob
counterclockwise 90° and pull out water tank drawer.
• Pay attention to the minimum level line when adding water. Always keep water level higher than
minimum level line, or noisy operation and water pump damage may result.
• When adding water, do NOT over ll above MAX level line.
• Always use clean water.
• After adding the water, close and lock the water tank drawer.
NOTE: In initial use, there may be some odor and minor discoloration of water. This is normal and
poses no harm to the unit or your health.
COOLING BOTTLE INSERTS: When used correctly, the water bottle inserts will absorb heat in the
water. As a result, the water temperature will drop, causing the air ow from the unit to be cooler than
the surrounding air temperature.
To use inserts:
1. Place the cooling bottle inserts in the freezer until completely frozen.
2. Place one of the inserts into the water tank and lock the tank. The cooling effect of the insert can
last up to 4 hours.
3. There are two cooling bottle inserts to provide continual use. One is active in the unit while the other
is being frozen in a freezer.
WARNING: DO NOT OPEN THE COOLING BOTTLE INSERTS OR ATTEMPT TO SWALLOW
THE CONTENTS, WHICH CAN BE HARMFUL IF INGESTED.