Use and Care Manual

HI
HEATER
ON/OFF
CLEAN
FILTER
COOLER/
HUMIDIFIER
OSCILLATION
SPEED TIMER
LOW 1H
2H
4H
6H
8H
MED
HI
NATURAL
SLEEP
FAN
1 COOLER / HUMIDIFIER MODE
Recirculates and lters the water located at the base to generate cool air
2 HEAT / FAN MODE
FAN Mode: will operate turbine as a fan only
HEATER Mode: will operate as a heater on a low speed setting
HI Mode: will operate as a heater on a high speed setting
Press this button multiple times to alternate from FAN to HEATER to HI
3 ON / OFF MODE
Will turn the entire unit on or off
4 CLEAN FILTER MODE
Indicator will show a light and beep every 100 hours of operation while being used
as a COOLER/HUMIDIFIER. This is to indicate that the honey comb lter located
at the rear of the unit needs to be taken out and rinsed, then place back into the
unit. Press and hold the COOLER/HUMIDIFIER button down to reset the CLEAN
FILTER MODE
5 VERTICAL AIR FLOW
OSCILLATION
Press this key to begin continuous air ow oscillation up and down; press again to
x air ow angle in place
6 HORIZONTAL AIR FLOW
OSCILLATION
Press this key to begin continuous air ow oscillation right and left; press again to
x air ow angle in place
7 SPEED MODES
LOW Mode: will operate fan turbine at low speed
MED Mode: will operate fan turbine at medium speed
HI Mode: will operate fan turbine at high speed
NATURAL Mode: will operate fan to mimic a natural breeze by alternately
increasing and decreasing the speed
SLEEP Mode: will operate the fan at LOW speed after two 30 minute periods of
HIGH and MEDIUM speed
8 TIMER
Allows you to toggle and set a specic time duration for operation (1-8 hours of
preset use)
9 REMOTE CONTROL
Receives operation signal from remote control
3
10
10 MAIN POWER SWITCH
Located on the side of the unit.
Once unit is plugged in, press
switch to (l) to power ON. Press
to (O) to power off