User's Manual

operating instructions for satisfying
RF exposure compliance.
IC Radio Frequency
Interference Statement
This device contains licence-exempt
transmitter(s)/receiver(s) that
comply with Innovation, Science and
Economic Development Canada’s
licence-exempt RSS(s). Operation is
subject to the following two
conditions:
- This device may not cause
interference.
- This device must accept any
interference, including interference
that may cause undesired operation
of the device.
The products are compliant with SAR
for general population/uncontrolled
exposure limits in IC RSS-102 and
has been tested in accordance with
the measurement methods and
procedures specified in IEEE 1528.
The transmitter module may not be
co-located with any other transmitter
or antenna.
TROUBLESHOOTING
-Make sure that the Aerobit
PeakFlow+ Reusable Turbine is
correctly inserted into the device.
-Make sure the turbine is not
spinning before starting the test.
-Make sure there is enough battery
before you do a test.
-Make sure the environment is not
too windy or bright.
-Make sure the Bluetooth is Enabled
on your Smartphone
Unable to setup? Unexpected errors
or outputs? Contact us immediately
and we will be more than happy to
help.