Instructions / Assembly

6
Figure 5
2.) With the white tape upward, apply approximately 77” of butyl sealant
rope around the perimeter of the adapter flange where the riser pipe will
meet the flange (Fig.5). Cut off remaining butyl sealant & set aside for
step 11. Overlap and knead the ends of the butyl rope together to
ensure a water-tight seal.
3.) Remove the white tape from the sealant rope and discard the tape.
4.) Center the riser pipe on the adapter flange so the gap is even all of the
way around. Do not apply downward pressure while adjusting the gap.
When the even gap is achieved, lightly lower the riser pipe onto the
butyl rope. As required, make final adjustment and apply firm downward
pressure to seat the riser pipe into the butyl rope. Apply the pressure all
around the riser pipe every 30 degrees.
5.) Locate the four (4) mounting dimples on the inside perimeter of the
adapter flange (Fig.6).
Butyl Sealant
Figure 6: Locate four mounting dimples
Mounting dimple
Locking Tab