Use and Care Manual

P/N: 100292

REV B

Instructions for Air line Extension Kits

P/N: 102312, 100297, & 100298

Installation tip: The air line causes frictional losses as the air passes through it, reducing the

amount of air delivered to the diffuser. To maximize efficiency, the shortest length of air line

should be used while avoiding sharp bends and kinks.

1.) Install the Aero-Stream® equipment as outlined in the Installation Guide.

Steps 2 - 4 apply to Remediator® and Pro-Line™ units, only:

2.) Remove the barbed fitting from the air line extending from the Aero-

Stream® equipment by cutting the air line as shown below.

3.) Select the (½” x ½”) connector from the kit.

4.) Wet the barbed fitting and insert into the air line from Step 2 above

and the end of the air line coming out of the Aero-Stream®

equipment.

PAGE 1
Instructions for Air line Extension Kits P/N: 102312, 100297, & 100298 Installation tip: The air line causes frictional losses as the air passes through it, reducing the amount of air delivered to the diffuser. To maximize efficiency, the shortest length of air line should be used while avoiding sharp bends and kinks. 1.) Install the Aero-Stream® equipment as outlined in the Installation Guide. Steps 2 - 4 apply to Remediator® and Pro-Line™ units, only: 2.
PAGE 2
Step 5 applies to Pro-Line Plus™ units, only: 5.) Wet the end of the (½” x ½”) barbed fitting clamped into the air line coming out of the Aero-Stream® equipment and slide an open end of the air line extension over it like shown in the picture above in Step 4. 6.) 7.) 8.) 9.) Utilizing the clamps provided, cinch air line to barbed connector on both splices. Lay the air line extension on the ground along the shortest path to the septic tank containing the sintered diffuser.