Use and Care Manual

Brown ring at water line

1. This is normal when the water used to fill the pool has high

iron content. Using “rust or stain remover” solution, wipe the

rust stain with damp sponge containing rust or stain remover.

Rinse sponge in solution periodically.

2. If these steps do not solve the problem call Aero-Spa™, LLC

Light scale on surface

1. This occurs when the water used to fill the pool is hard. Using

a sponge or “Scouring pad” pad, wipe surface to remove

scale. Care should be used if using a “Scouring pad” pad to

ensure the surface of the pool is not damaged.

2. If these steps do not solve the problem call Aero-Spa™, LLC

Light brown material on surface of pool walls

1. This occurs when the water is not adequately circulated in the

pool. Using a sponge, wipe surface to remove scale.

2. Increase pool circulation pump cycle time. Synchronize

circulation pump and Aero-Spa™ run time.

3. If these steps do not solve the problem call Aero-Spa™, LLC

Water is normally clear but turns cloudy during or just after use –

1. Increase the cycle run time by 25%

2. If these steps do not solve the problem call Aero-Spa™, LLC

Water back siphoned into the ozone tube and or the ozone generator

1. A small amount of moisture can be considered normal in high

humidity conditions and in such a case nothing needs to be

done. If there is more than a few drops proceed to step 2.

below

2. Turn off all power by unplugging Aero-Spa™ from the 120

volt power outlet. Remove the sintered diffuser from the pool

and lay it on the ground at a lower elevation than the

generator. Allow the unit to purge the water from the ozone

tube. When complete, reinstall sintered diffuser in pool and

make sure the air lock is installed as described in the

installation procedure.

3. If these steps do not solve the problem call Aero-Spa™, LLC