Use and Care Manual

TROUBLESHOOTING

Aero-Spa™ not running

1. Reset GFCI breaker. If this problem persists replace GFCI

breaker

2. Reset circuit breaker at house fuse panel. If this problem

persists call Aero-Spa™, LLC

3. If these steps do not solve the problem call Aero-Spa™, LLC

Water is cloudy

1. Increase the run time cycle

2. Repeat step 1 until water clarity improves

3. If these steps do not solve the problem call Aero-Spa™, LLC

No bubbles coming from sintered diffuser

1. Verify Aero-Spa™ is running

2. Verify ozone tube is not broken

3. Verify ozone tube is not pinched or disconnected

4. If these steps do not solve the problem call Aero-Spa™, LLC

Strong ozone odor near Aero-Spa™

1. Verify ozone tube is not broken

2. Verify ozone tube is not pinched or disconnected

3. Turn off air pump and call Aero-Spa™, LLC

Strong ozone odor in pool

1. Reduce cycle run time 25%. Repeat if odor remains strong

after 1 hour.

2. Turn off air pump and call Aero-Spa™, LLC

Ozone tube is cloudy in color and not flexible

1. This is normal, periodically check for cracks in ozone tube

2. Call Aero-Spa™, LLC for replacement parts.

Sintered diffuser is turning brown

1. This is normal when the water used to fill the pool has high

iron content. The diffuser can be soaked in “rust or stain

remover” or similar product and rinsed thoroughly after

soaking.

2. If these steps do not solve the problem call Aero-Spa™, LLC