Use and Care Manual

Improper installation of the grounding

plug can result in a risk of electric

shock. If repair or replacement of the

cord or plug is necessary, do not

connect the grounding wire to either flat

blade terminal. The wire with insulation

having an outer surface that is green

with or without yellow stripes is the

grounding wire. Check with a qualified electrician or

serviceman if the grounding instructions are not completely

understood, or if in doubt as to whether the product is

properly grounded.

b) Do not modify the plug provided; if it will not fit the outlet,

have the proper outlet installed by a qualified electrician. This

product is for use on a nominal 120-volt circuit and has a

grounding plug that looks like the plug illustrated (type 5-15P)

in Figure 6. Make sure that the product is connected to an

outlet (type 5-15R) having the same configuration as the plug.

No adapter should be used with this product. This product

has an automatically reset thermal limiter, which shuts off the

entire product when an elevated temperature condition exists.

When the product cools it will automatically restart.

c) Only if required, obtain a UL outdoor rated extension cord

Never locate the Aero-Spa™ generator closer than 10’ from

the pool.

d) Insert the electrical plug from the Aero-Spa™ into the

extension cord.

e) Insert the Plug into the electrical outlet identified in step 3)

Figure 5.

f) Insert the 120 VAC power cord or the extension cord

identified in 3) above into the cycle timer

4) Turning Product On

a) The equipment will begin to operate. You will hear a faint hum

from the generator and a steady bubble stream will be

emitted from the diffuser.

Figure 6