Instructions / Assembly

Each foil packet contains:

Test Strip

Test Vial

Disposable Pipette

Desiccant (to be discarded)

Do not open foil pouch until immediately prior to

use

Use the sample viral provided to run the test

Do not re-use any test strips, pipettes, or vials

Store test at 50-86°F (10-30°C)

The Watersafe® Rapid Bacteria Test for pools and spas

in an antibody-based test kit for detecting the presence

of bacteria in water, including E. Coli, Pseudomonas

aeruginosa, species of Shigella, Enterobacter, and many

other coliform and non-coliform bacteria.

Before you begin…

This kit contains information and materials, which are derived in whole or

in part from information and materials supplied to Aero-Spa LLC, and are

protected by their respective copyright. WaterSafe is a trademark of Silver

Lake Research Corporation.

PAGE 1
The Watersafe® Rapid Bacteria Test for pools and spas in an antibody-based test kit for detecting the presence of bacteria in water, including E. Coli, Pseudomonas aeruginosa, species of Shigella, Enterobacter, and many other coliform and non-coliform bacteria.
PAGE 2
1. Open foil pouch and take out all contents. 2. Using a clean pipette, place exactly ONE pipette-full of water into the test vial. To draw up sample, tightly squeeze the bulb at the end of the pipette and place the open end into water sample. Release the bulb to pick up sample, then squeeze again to expel sample into vial. 3. Gently swirl vial. Let stand five (5) minutes. Swirl vial again and return vial to flat surface. 4. Place test strip into sample vial with arrows pointing down 5. Wait 10 minutes.