Instructions / Assembly

MAINTENANCE (CLEANING)
1.
Disconnect power source before working on unit.
Routine maintenance must be done every year.
WARNING:
Fig.16
3.
2.
Fig.17
Clean grille. (Don’t put into hot water. Use
non-abrasive kitchen detergent then wipe dry with
clean cloth). (Fig.17)
The grille should be dry after cleaning before
reattaching to fan motor.
1.
2.
3.
CAUTION:
Louver
INSTALLATION II (RETROFIT) CONTINUED
Fig.15
4.
5.
9
Follow step 10 of Installation I (NEW
CONSTRUCTION page 7-8) to complete installation.
Push the fan body upwards until the fan body is
secure with the joint, and secure them by using the
remaining 3 self-drilling screws(ST4X30) (Fig.15)
3 Screws
(ST4x30)
Never use gasoline, benzene, thinner, or any
other such chemicals for cleaning the ventilating
fan.
Do not immerse motor in water when cleaning.
Do not soak resin parts in water over 140°F
(60°C).
Remove grille. (Squeeze mounting spring and
pull down carefully). (Fig.16)