Instructions / Assembly

Fig.5
Push the fan body upwards until the fan body is
stopped by the buckle on the adapter and secure
the fan body by using the remaining 3 self-drilling
screws (ST4X30). (Fig.5)
6
Fig.7
Attach cable clamp to knock-out
plate.Knock-out plate mounts to
outside of housing and may be
positioned as desired.
Connect
wires
Nuts
Screw from
Parts Bag
Ⅱ
Ⅲ
Ⅰ
Ⅳ
Install a circular duct and secure it with clamps
or ties and seal it with mastic or approved duct tape.
A 4＂, 5＂, or 6＂circular duct is needed to connect
to relevant part of adaptor. (Fig.6)
Fig.6
Circular duct
Duct tape
INSTALLATION I（NEW CONSTRUCTION）CONTINUED
Hold the fan body to prevent falling before fixing
the screws.
CAUTION:
！
Buckle
Fan body
3 Screws
(ST4x30)
5.
6.
Remove the knock-out plate and secure conduit
or wire protector nut to knock-out hole. (Fig.7. )
7.
Refer to wiring diagram on page 4.
Using UL approved wire nuts, connect house power
wires to the ventilating fan wires (Fig.7. ), then
attach it to fan body.
Follow all the local eletrical safety codes as well
as the National Electrical Code (NEC).
Ⅰ
Ⅱ
IMPORTANT: