Use and Care Manual

ManualsBrandsAero-Pond ManualsPlumbingUrban Pond Kit

DANGER: Improper installation of the grounding plug can

result in a risk of electric shock. If repair or replacement of

the cord or plug is necessary, do not connect the

grounding wire to either flat blade terminal. The wire with

insulation having an outer surface that is green with or

without yellow stripes is the grounding wire.

Check with a qualified electrician or serviceman if the grounding

instructions are not completely understood, or if in doubt as to whether

the product is properly grounded. Do not modify the plug provided; if it

will not fit the outlet, have the proper outlet installed by a qualified

electrician.

This product is for use on a nominal 120-volt AC circuit and has a

grounding plug that looks like the plug illustrated in Figure 1 on page

6. Make sure that the product is connected to a GFCI outlet having the

same configuration as the plug. No adapter should be used with this

product. This product has an automatically reset thermal limiter, which

shuts off the entire product when an elevated temperature condition

exists. When the product cools, it will automatically restart.

Figure 1

Place the Housing on the ground next to the power outlet. The Housing

must always be resting on its base in a horizontal position. Ensure the

selected location is not prone to temporary flooding such as a low area

or near a gutter downspout. Evidence of flooding will void warranty.

TIP: Place the Housing on a patio block or similar surface

to elevate the unit above the ground. This will insure that

the unit does not become flooded and will keep the unit

free of yard debris.

GFCI

Outlet

Housing

’s

3 prong

plug with ground

WARNING: Do not cover or encase the Housing as

adequate ventilation is required to keep the motor cool. In

addition, the Housing must always be above the effluent

level to prevent backflow.

Peak performance is obtained when the Housing is connected to the

Diffuser with the shortest length of Air Line. If the air line is not of

sufficient length, measure the distance in feet from the Housing to the

end of the Air Line. Contact Aero-Stream

to purchase a properly sized

Air Line Extension Kit to connect to the Air Line packaged with the

product.

WARNING: an improperly sized air line will detrimentally affect

the performance and life of this product and may void the

warranty.

If the alternate location for the Housing is selected, obtain a UL outdoor

rated extension cord sized in accordance with Table 1 on page 8 and

long enough to reach from the electrical outlet to the alternate location.

If an extension cord is used, select a cord with an end that most closely

matches the Aero-Stream

product cord. Use only a 3-wire extension

cord that has a 3-blade grounding plug and a 3-slot receptacle that will

accept the plug on the product. Wrap the joint between the cords with at

least two layers of UL listed electrical tape. This will avoid nuisance

tripping of the GFCI device.

Make sure your extension cord is in good condition. When using an

extension cord, be sure to use one heavy enough to carry the current

your product will draw. For lengths less than 25 feet, No. 18 AWG

extension cords should be used. Otherwise, follow the

recommendations described in Table 1 on page 8. An undersized cord

will cause a drop in line voltage resulting in loss of power, overheating

and may void warranty.

Trim the Air Line running from the pond to the Housing of any excess

length. Connect to the short air line from the Housing. Install the Hose

Clamp around the Air Line and barbed fitting and cinch tight.

TIP: If the Housing is located more than 24”[.7m] from the

pond, bury the Air Line 2”-3”[80mm] below the surface to

protect it from damage.