User Manual
Table Of Contents
- 1. REMOTE CONTROL
- 2. FUNCTIONS AVAILABLE THROUGH THE REMOTE CONTROL
- switching the unit on or off
- SELEcting an operating mode
- SETTING THE OPERATING SETPOINT
- SETTING THE FAN SPEED
- SETTING THE MOTORISED DISCHARGE FIN (SWING)
- SETTING A SYSTEM TIME
- SETTING or cancelling a programmed SWITCH OFF (TIMER OFF)
- SETTING or cancelling a programmed switch on (TIMER on)
- ACTIVATING / DEACTIVATING THE EXTENDED VENTILATION
- VIEW THE AMBIENT AIR, SET POINT OR OUTDOOR AIR (IN THE DISPLAY OF THE INDOOR UNIT)
- ACTIVATING / DEACTIVATING THE TURBO FUNCTION
- activating / deactivating the NIGHT-TIME COMFORT FUNCTION
- ACTIVATING / DEACTIVATING the indoor unit’s display
- setting or removing the button lock
- SETTING THE UNIT OF MEASUREMENT
- activating/deactivating the anti-freeze function
- ACTIVATING OR DEACTIVATING THE ENERGY SAVING FUNCTION
- activating/deactivating the ifeel function
- ACTIVATE OR DEACTIVATE THE WIFI FUNCTION (ONLY WITH THE ACCESSORY WIFIKIT/WIFIKIT10)
- REPLACING THE REMOTE CONTROL’S BATTERIES
9
SETTING THE MOTORISED DISCHARGE FIN SWING
If the unit is on, while pressing the button it
activates the swing of the motorized supply air fin. The
fin allows to change the air flow in the room depending
on the set position; The logic where this function is
managed:
When the unit is on, while pressing the button it’s
possible to set one by one the following steps:
Fluctuation
continues(*)
Fixed
(Step 1)
Fixed
(Step 2)
Fixed
(Step 3)
Fixed
(Step 4)
Fixed
(Step 5)
Fluctuation
continues (*)
Fluctuation
continues (*)
Fluctuation
continues (*)
(*) Are present in spite of different icons for
continuous oscillation, all 4 trigger the same
mode: fluctuation continues from the lowest
point to the highest point
, ,
=
NOTE:
In order to block in a precise position the fin during the
swing mode, keep the button , pressed for at least 2
seconds, and release it once the fin reaches the desired
position.
Motorised discharge
fin setting