User Manual
Table Of Contents
- 1. REMOTE CONTROL
- 2. FUNCTIONS AVAILABLE THROUGH THE REMOTE CONTROL
- switching the unit on or off
- SELEcting an operating mode
- SETTING THE OPERATING SETPOINT
- SETTING THE FAN SPEED
- SETTING THE MOTORISED DISCHARGE FIN (SWING)
- SETTING A SYSTEM TIME
- SETTING or cancelling a programmed SWITCH OFF (TIMER OFF)
- SETTING or cancelling a programmed switch on (TIMER on)
- ACTIVATING / DEACTIVATING THE EXTENDED VENTILATION
- VIEW THE AMBIENT AIR, SET POINT OR OUTDOOR AIR (IN THE DISPLAY OF THE INDOOR UNIT)
- ACTIVATING / DEACTIVATING THE TURBO FUNCTION
- activating / deactivating the NIGHT-TIME COMFORT FUNCTION
- ACTIVATING / DEACTIVATING the indoor unit’s display
- setting or removing the button lock
- SETTING THE UNIT OF MEASUREMENT
- activating/deactivating the anti-freeze function
- ACTIVATING OR DEACTIVATING THE ENERGY SAVING FUNCTION
- activating/deactivating the ifeel function
- ACTIVATE OR DEACTIVATE THE WIFI FUNCTION (ONLY WITH THE ACCESSORY WIFIKIT/WIFIKIT10)
- REPLACING THE REMOTE CONTROL’S BATTERIES
8
SETTING THE OPERATING SETPOINT
All the operating modes (except the automatic one)
require an room air temperature value to control to:
this is called the operating setpoint.
If the unit is on (and the automatic mode is not
selected), pressing the and buttons allows
decreasing or increasing the operating setpoint. The
setpoint value is displayed in the central part of the
remote control’s display.
SETTING THE FAN SPEED
If the unit is on (and the automatic or dehumidification
modes are not selected), pressing the button
allows the selection of the fan speed. Pressing the
button allows changing the fan speeds as shown in the
icons below, in the following sequence:
AUTO MINIMUM AVERAGE MAXIMUM
Operating setpoint
Setting the fan speed
NOTE:
Besides the three speeds (AUTO automatically
selects the best speed based on the room
temperature), there is a function called TURBO
(explained earlier) which adds a further speed
above the maximum speed.