User Manual
Table Of Contents
- 1. REMOTE CONTROL
- 2. FUNCTIONS AVAILABLE THROUGH THE REMOTE CONTROL
- switching the unit on or off
- SELEcting an operating mode
- SETTING THE OPERATING SETPOINT
- SETTING THE FAN SPEED
- SETTING THE MOTORISED DISCHARGE FIN (SWING)
- SETTING A SYSTEM TIME
- SETTING or cancelling a programmed SWITCH OFF (TIMER OFF)
- SETTING or cancelling a programmed switch on (TIMER on)
- ACTIVATING / DEACTIVATING THE EXTENDED VENTILATION
- VIEW THE AMBIENT AIR, SET POINT OR OUTDOOR AIR (IN THE DISPLAY OF THE INDOOR UNIT)
- ACTIVATING / DEACTIVATING THE TURBO FUNCTION
- activating / deactivating the NIGHT-TIME COMFORT FUNCTION
- ACTIVATING / DEACTIVATING the indoor unit’s display
- setting or removing the button lock
- SETTING THE UNIT OF MEASUREMENT
- activating/deactivating the anti-freeze function
- ACTIVATING OR DEACTIVATING THE ENERGY SAVING FUNCTION
- activating/deactivating the ifeel function
- ACTIVATE OR DEACTIVATE THE WIFI FUNCTION (ONLY WITH THE ACCESSORY WIFIKIT/WIFIKIT10)
- REPLACING THE REMOTE CONTROL’S BATTERIES
16
ACTIVATE OR DEACTIVATE THE WIFI FUNCTION ONLY
WITH THE WIFI ACCESSORY INSTALLED
The units can be controlled by a WIFI system, if the
accessory WIFI has been planned; to activate or
deactivate the WIFI function, press the button ; the
display shows the icon ( ) indicating that the function
is now active.
ACTIVATE OR DEACTIVATE THE
WIFI FUNCTION
ATTENTION:
in order to use this function it’s MANDATORY to
install in the unit the specific accessory WIFI.
ACTIVATING/DEACTIVATING THE IFEEL FUNCTION
The IFEEL function uses a temperature probe inside
the infrared remote control in order to comunicate
the room temperature to the unit and therefore it
sets the operation of the unit, to give the maximum
comfort to the user.
While the unit is on, press at the same time the buttons
and
to activate and deactivate this function;
the display will show or hide the icon ( ), to indicate
whether the function is activated or deactivated.
Setting the
IFEEL function
NOTE:
The function uses the set chose by the user,
and guarantees a higher comfort if the remote
controller is placed near the user (within the
maximum distance of 8 meters).
During this function is it recommended to keep
the remote away from heating sources that could
change the real room temperature reading
WIFI RESET
To reset the WIFI device with the factory values, while
the unit is OFF, press at the same time (for at least one
second) the buttons
MODE
and
WIFI
.