User Manual
Table Of Contents
- 1. REMOTE CONTROL
- 2. FUNCTIONS AVAILABLE THROUGH THE REMOTE CONTROL
- switching the unit on or off
- SELEcting an operating mode
- SETTING THE OPERATING SETPOINT
- SETTING THE FAN SPEED
- SETTING THE MOTORISED DISCHARGE FIN (SWING)
- SETTING A SYSTEM TIME
- SETTING or cancelling a programmed SWITCH OFF (TIMER OFF)
- SETTING or cancelling a programmed switch on (TIMER on)
- ACTIVATING / DEACTIVATING THE EXTENDED VENTILATION
- VIEW THE AMBIENT AIR, SET POINT OR OUTDOOR AIR (IN THE DISPLAY OF THE INDOOR UNIT)
- ACTIVATING / DEACTIVATING THE TURBO FUNCTION
- activating / deactivating the NIGHT-TIME COMFORT FUNCTION
- ACTIVATING / DEACTIVATING the indoor unit’s display
- setting or removing the button lock
- SETTING THE UNIT OF MEASUREMENT
- activating/deactivating the anti-freeze function
- ACTIVATING OR DEACTIVATING THE ENERGY SAVING FUNCTION
- activating/deactivating the ifeel function
- ACTIVATE OR DEACTIVATE THE WIFI FUNCTION (ONLY WITH THE ACCESSORY WIFIKIT/WIFIKIT10)
- REPLACING THE REMOTE CONTROL’S BATTERIES
13
NOTE:
The night time health function is deactivated by
switching off the unit, and on restarting will not
be active; this function can be activated at any
time.
ACTIVATING / DEACTIVATING THE NIGHTTIME
COMFORT FUNCTION
The night-time comfort function controls the air
conditioner in an optimal way during the night. The
following logic is applied:
• In cooling or dehumidification: the temperature
setpoint is gradually increased to guarantee
maximum comfort combined with energy saving;
• In heating: the temperature setpoint is gradually
decreased to guarantee maximum comfort
combined with energy saving;
If the unit is on (except in automatic or ventilation
mode), pressing the activates or deactivates the
night time health function. If the function is active the
icon is displayed on the remote control.
Setting night-time
comfort function
ACTIVATING / DEACTIVATING THE INDOOR UNIT’S
DISPLAY
The display on the indoor unit must be activated
using the remote control; To activate the display
on the front panel of the indoor unit press the
button on the remote control.
Once the button is pressed the symbol will
appear on the remote control’s display, indicating
the activation of the display on board of the indoor
unit. Pressing the button again deactivates the
display.
Activating the display on board
of the indoor unit