User Manual

12
VIEW THE AMBIENT AIR, SET POINT OR OUTDOOR AIR
IN THE DISPLAY OF THE INDOOR UNIT
Through the use of the remote control it is possible to
display the room temperature value read by the indoor
unit, or display the current operating setpoint used
by the unit. This information is displayed on board the
indoor unit’s display.
If the unit is on and if the indoor unit display is
enabled, pressing the key allows the display of the
following values on the indoor unit’s display (successive
pressing passes from one to the next):
None
visualisation
Set
point
Ambient
air
Outdoor
air
NOTE:
The default display on the indoor unit’s display
is the operating setpoint; the room temperature
value is displayed for 3 seconds after which
the display returns to the operating setpoint.
To display the room temperature again it is
necessary to select the corresponding symbol on
the remote control.
On some models there is no external air reading
( ), in these cases the working set ( ) will be
displayed again.
Display of room
temperature or
operating setpoint of
the indoor unit
ACTIVATING / DEACTIVATING THE TURBO FUNCTION
The unit allows the setting of three fan speeds during
the various operating modes (except the automatic
mode and the dehumidification mode). There is an
additional speed called turbo.
If the unit is on, pressing the button activates or
deactivates this function. If the function is active the
icon
MODEON/OFF
FAN
CLOCK
X-FAN
TURBO SLEEP LIGHT
TEMP
TIMER OFF
TIMER ON
is shown on the remote control’s display.
Setting the
TURBO function