Operation Manual

TO SET - WET ACTIVATION (while in the Surface Mode)

Factory set ON, this feature can also be set OFF (disabled). When

set ON, the XR2 will automatically Activate and enter Dive Mode

upon immersion in water and descent to 5 feet (1.5 meters).

WARNING: If the Wet Activation feature is set OFF,

the XR2 must be manually (push button) activated

prior to commencing a dive.

 Depress Both buttons simultaneously, release when SET 2 ap-

pears (4 seconds).

 Press and release the Advance (Front) button, the Units screen

appears with the set point flashing.

 Press and release the Advance (Front) button 15 more times

(14 more times if a dive was made with Digital Gauge Mode set

ON).

 The graphics ACT and H2O appear with the set point graphic

ON (or OFF) flashing (Fig. 40).

 Press and release the Select (Side) button to toggle between ON

and OFF.

 Press and release the Advance (Front) button to accept the set-

ting and revert to Surface Mode.

Fig. 40 - Set Wet Activation