Operation Manual

TO SET - ELAPSED DIVE TIME (EDT) ALARM

(while in the Surface Mode)

Factory set for 0:00 (hr:min), the EDT Alarm can be set to values

between 0:10 and 3:00 (hr:min) in increments of 0:05 (hr:min).

 Depress Both buttons simultaneously, release when SET 1 ap-

pears (2 seconds).

 Press and release the Advance (Front) button, FO2 appears

with the set value flashing.

 Press and release the Advance (Front) button 2 more times.

 The graphic EdT, and Alarm and Dive Time (wave/clock) icons

appear with the Elapsed Dive Time value flashing (Fig. 23).

 Press and release the Select (Side) button until the desired

Alarm value appears, or depress and hold the button to scroll

through the Set Points at a rate of 4 per second.

 Press the Advance (Front) button to accept the setting and ad-

vance to PC Interface, or depress and hold Both buttons for 2

seconds to revert to Surface Mode.

 The unit reverts to Surface Mode in 2 minutes if no button is

pressed.

Fig. 23 - Set Elapsed Time Alarm