Operation Manual

Battery Installation

 Slide a new 3 volt type CR2450 Lithium Battery, negative (-)

side down into the Battery Cavity. Slide it in from the right side

and ensure that it slides under the contact clip on the left rim of

the cavity (Fig. 55).

 Orient the Retaining Bar across the lower portion of the Battery

and carefully push it down into position (Fig. 56).

Battery Hatch and Hatch Retaining Ring Installation

 Replace the Hatch O-ring with a new one which must be a genu-

ine Oceanic part that can be purchased from an Authorized Oce-

anic Dealer. Use of any other O-ring will void the warranty.

 Lightly lubricate the new Hatch O-ring with silicone grease and

place it on the inner rim of the Battery Hatch (Fig. 57). Ensure

that it is evenly seated.

 Slide the Hatch Retaining Ring, top portion first (small open-

ing), onto your thumb.

 Carefully place the Battery Hatch (with O-ring) into position on

the rim of the Battery Compartment, then press it evenly and

completely down into place with your same thumb.

 Maintain the Battery Hatch securely in place and, using your

other hand, slide the Retaining Ring down off your thumb and

into position around the Battery Compartment.

 The tabs on the Retaining Ring fit down into the two slots lo-

cated at the 2 and 8 o'clock positions.

Fig. 57 -O-Ring Orientation

Fig. 55 - Inserting Battery

Fig. 56 -Inserting Retaining Bar