Operation Manual

39
Log Data will not be stored in the unit's memory until the 10
minute Transition Period on the surface is completed.
Once 10 minutes have elapsed, the Surface Mode icon and Surface
Interval time display colon stop flashing indicating that the Dive
and Transition Period are completed, and a subsequent Descent
will be considered a new dive.
If you Descend during the 10 minute Transition Period, time under-
water will be considered a continuation of that dive. Time spent at
the surface will not be added as Dive Time.
AFTER THE TRANSITION PERIOD (THE FIRST 2 HOURS)
For the remainder of the first 2 hours after surfacing, information
will continue to be displayed as the Surface Sequence, scrolling
through Surface Mode > Time to Fly > Time to Desaturate > Dive
Planner. You will have full access to Log Mode and Set Mode.
Time to Fly/Desaturate
The Time to Fly and Desat Timers begin counting down 10 min-
utes after surfacing from a dive (after the Transition Period).
The FLY countdown (Fig. 43) always begins at 23:50 (hr:min) and
the Desat countdown (Fig. 44) at 23:50 (maximum).
Fig. 43 - Time to Fly
Fig. 44 - Time to Desaturate