Installation guide

WS3083
- 16 -
symbol appears in the display.
Maximum light intensity value (since last reset). Resetting the maximum light intensity value -
when both the light intensity value and MAX icon are flashing, hold the ENTER key for 3s, the
maximum light intensity value will be reset to the current reading.
Rain
Press the MENU key thirteen times to select the RAIN section, the RAIN section digits will start flashing.
Press the UP or DOWN key to change the period over which rain is measured (1h, 24h, Week, Month and
Total rain). Note: The 24h setting resets at midnight each day.
Press the ENTER key to select the following modes, then press the UP or DOWN key to set the value:
Rainfall units - select between mm and inch.
Rain high alarm (press ON/OFF to enable/disable). If the alarm is enabled, an alarm symbol
appears in the display.
Maximum rainfall (since this was last reset). Resetting the maximum rainfall value - when both the
rain value and MAX icon are flashing, hold the ENTER key for 3s, the maximum rain value will be
reset to the current reading.
Clearing Total rainfall - when both the Total rain value and the word CLEAR are flashing, hold the
ENTER key for 3s, the Total value will be reset to zero (1h, 24h, Week, and Month rain values will be
reset to zero automatically).
Memory
Press the HISTORY key to activate the history data display. Press the DOWN key to toggle backwards to see
earlier weather history data together with its time stamp, press the UP key to see more recent weather
history. When the history data is displayed, the corresponding time will be displayed in the time section
area (the history data saving interval is preset to 30 minutes).
Pressing the ENTER key will trigger the memory clear procedure, the word “CLE” will appear and the memory
usage icon will be flashing. Pressing and holding the ENTER key for 3 seconds will clear the memory.
Note: Historical values for some variables are only available once downloaded to PC and will appear as dashes
on the Base Station.
Reset To Factory Default Settings
While in normal display, press and hold the UP key for 20 seconds to reset all settings to the default settings.