Installation guide

WS3083
- 15 -
The UV Index has a scale of 1-12 as follows:
Extreme: 10, 11, 12
Very High: 7, 8, 9
High 5, 6
Moderate: 3, 4
Low: 0, 1, 2
Wind
Press the MENU key eleven times to select the WIND section, the WIND section digits will start flashing. Press
the UP or DOWN key to shift the display between Average wind speed and Gust (default Average wind speed).
Note: Average wind speed is the average speed over the 48 second period between signal transmissions. In
gusty conditions this may appear as though wind speed is being under reported as low winds and high winds
are averaged across the 48 second interval. Setting wind speed to Gust will display the maximum wind
speed during the 48 second period which can often be more meaningful in these conditions.
Press the ENTER key to select the following modes, then press the UP or DOWN key to set the value:
Wind speed units - select between km/h, mph, m/s, knots, bft.
Wind speed high alarm (press ON/OFF to enable/disable). If the alarm is enabled, an alarm symbol
appears in the display.
Wind direction alarm (press ON/OFF to enable/disable). If the alarm is enabled, an alarm symbol
appears in the display.
Maximum wind speed (since last reset). Resetting the maximum wind speed value - when both the
wind speed value and MAX icon are flashing, hold the ENTER key for 3s, the maximum value will be
reset to the current reading.
Light
Press the MENU key twelve times to select the LIGHT section, the LIGHT section digits will start flashing. Press
the UP or DOWN key to change the light intensity display mode between W/M
2
, FC and LUX.
Press the ENTER key to select the following modes, then press the UP or DOWN key to set the value:
Light intensity high alarm (press ON/OFF to enable/disable). If the alarm is enabled, an alarm