Technical information

Airfusion Radar Installation Instructions
6 | Page
INSTALL THE CANOPY COVER
• Loosen 2 screws (2) from the mounting bracket. Fig. 5
• Loosen 2 screws (1) by half thread from the mounting bracket. Fig. 5
• Lift the hanging plate of the fan assembly up to the mounting bracket and let the L-shape slot on the hanging plate
go through the screws (1) on the mounting bracket. Turn the hanging plate until it locks in place at the end section
of the L-shape slot and secure it by tightening the two screws (2). Avoid damaging the electrical wiring prepared
previously.
• Finally attach the motor housing to the hanging plate and secure it by pushing the hooks (3) into the slot holes and
turn it anti clockwise.
BLADE INSTALLATION
• Insert the blade screws through the blade assembly in the following order - bracket kit (2) and blade (1).
Attach the blade assembly to the motor and secure it by tightening the 2 screws (3). Fig. 6
• Repeat to install the other blades.
• Finally install the bottom cover (4) to the shaft of the motor by rotating it clockwise.
Fig. 6
Fig. 5