Specifications
4. Controls
Left to right:
input Instrument input (mono jack)
high / low Sensitivity selector switch
high: high sensitivity
low: low sensitivity
gain input level control
clip Overload indicator
mute Amp mute (also controllable via footswitch)
compressor Dynamic compressor (for narrowing dynamic range)
threshold Sets the level above which the compressor becomes
active (clockwise lower level, i.e. higher compression).
ratio Sets the compression ratio
(clockwise higher compression).
active Control indicator. Lights up when the compressor beco-
mes active (depending on input signal)
o / on Turns the compressor on/o.
equalizer 3-band equalization (see also technical specications)
colour Midrange contour lter. Boosts presence range and
slightly cuts low mids.
bass Bass control
bass boost Additional lower bass boost
middle Midrange control
freq. Center frequency of midrange control (200 … 2000 Hz)
wide / narrow Bandwidth of midrange control (wide / narrow)
treble Treble control
tone balance EQ balance shift (allows bass or treble accentuation or a
combination of both.)
balance Alters the type of equalization as follows:
Left stop: bass boost
Center setting: bass and treble boost
Right stop: treble boost and bass cut
intensity Controls the intensity of the balance EQ
Left stop: no eect
Right stop: full eect as described under ’balance‘
master Overall volume control
power Operation indicator