User`s manual

AEQ PHOENIX MERCURY
33
Enter the IP address of the remote unit, either
manually or getting it from the buttons:
By clicking here, the last URI “Calls”, the URIs in the “Equipment Contacts” book or the
available “IP” addresses are shown respectively, but only those with formats compatible
with channel and communication type.
• It is mandatory that the called unit URI is specified in any of the following formats,
adequate for Direct SIP communications:
“<equipment’s_name>@<equipment’s_IP_address>” (for example:
“phxme_231@172.26.5.57”).
If the SIP port of the other end is not 5060 (standard SIP port), the identifier must
include the port in use:
For example: “phxme_ 231@172.25.32.11:5061”.
VERY IMPORTANT: <equipment’s_name> must not be longer than 19 characters
• Press the green “Call” button on the screen, to make the call.
• You can observe the changes of status from OK to CONNECTED and synchronized:
• Verify that the “SYNC“ LED beneath the “CALL“ button is lighted in green to indicate
that the communication has been successfully established.
• Press the “ON AIR“ button to allow the transmission of full-duplex audio for that
channel.
• Send audio from one equipment to another verifying that the “Tx” and “Rx”
audio presence indicators change to green.
4.5.3.1. Finalizing an IP communication in DIRECT SIP mode.
• In order to hang call, just click on “CALL” button in one of both codecs. A confirmation
message will appear and the call will be disconnected after acceptance.