User`s manual

AEQ FORUM - DIGITAL AUDIO MIXER FOR BROADCAST APPLICATIONS
14
The three rotary encoders are related to the remaining lines of the menu. Each screen is
described in chapter 3 of this manual but the thumb-rule for the association of the rotary
encoder to the visible functions is: option visible to the left or in the upper part of the menu is
controlled from the encoder located to the left. In many cases the encoders are represented and
labelled on the screen for easy operation.
2.1.2.4. Control Monitoring section
Located in the lower right corner of the AEQ FORUM control surface are three rotary encoders,
a tow-coloured display and four keys.
In the tow-coloured OLED display are shown the output levels for the control monitor signals
and the selected sources in each case, control headset, control speakers and CUE.
Control Monitoring section
The three rotary encoders, from left to right:
1. MONITOR: controls the audio level for the physical output for the Control Room
Monitors. To decrease the level turn the encoder to the left. To increase the level
turn the encoder to the right.
2. HP / SOURCE: controls the audio level for the physical output for the headphones.
To decrease the level turn the encoder to the left. To increase the level turn the
encoder to the right. This encoder can also be used to select the signal to monitor
and is associated with the key called SEL: Press to access a list of signals, and
turning the encoder moves up or down in the list of signals. Pushing the encoder a
second time confirms the selection of the highlighted signal.
Control Monitoring display
3. CUE: controls the audio level of the CUE speaker of the AEQ FORUM. To
decrease the level turn the encoder to the left. To increase the level turn the
encoder to the right.