User`s manual

AEQ FORUM

Digital audio mixer for broadcast applications

4.3.2.6. Configuration of “Cue Reset” programmable key.

“Cue Reset” option allows you to configure a programmable key as a key to disconnect

immediately all the signal sendings to the CUE bus at that moment. A key set to this function is

assigned with a dedicated icon.

The lower part of the “Programmable Keys” submenu will show no options when this

configuration mode is selected.

The activation of this “Cue Reset” function will have the following result in AEQ FORUM control

surface: when the key is pressed, all the circuits or channels being sent to the CUE bus of the

mixer will be disconnected and the LEDs of all the “CUE” keys that may be active will be turned

off.

4.3.2.7. Configuration of “Orders” programmable keys.

Programmable keys that are set to “Orders” enables you to send the orders microphone to the

selected output channel. A key set to this function is assigned with a dedicated icon.

The lower part of the “Programmable Keys” submenu will allow you to configure the output

associated to the programmable key. In order to be able to configure the programmable key (or

edit a previously configured key), you have to press the “Edit Configuration” button, to active

and allows you to assign to that key any of the outputs defined in the system.

These keys works as follows: when you press and keep pressed the key you send to the

selected output the orders microphone (any routing previously defined for that output is

deactived). When you stop pressing the programmable key, you stop sending the orders

microphone and the previous routing is recovered.