User`s manual

EAGLE

Multi-Standard Dual-Channel Digital Audio Codec

2. EQUIPMENT POWER SUPPLY

2.1. Equipment power supply. The power connector (1) is located on the unit’s back panel.

The equipment receives power through the connector designed for that purpose (1), using the

cable supplied. The equipment may be operated with alternating voltage of between 90V and

250V at 50 or 60 Hz; this type of power is considered “universal,” as it will allow the EAGLE to

be used in any country in the world with no need for a voltage selector switch. Consumption is

approximately 40 VA.

Inside the power connector compartment, there are two 1 Amp. Slow Blow fuses (T), one of

them used as a spare.

2.2. Turning on the equipment. Before connecting it, make sure the power switch, located on

the front of the unit, is in the OFF position.

Once the power cable is properly connected to the equipment, you can connect the power cable

to the electrical power outlet.

Activate the power switch (ON position). If all instructions have been correctly followed, the

Power ON LED will light up, indicating that the equipment is receiving power.