User`s manual

EAGLE
Multi-Standard Dual-Channel Digital Audio Codec
44
6. FIRMWARE UPGRADING
WHEN UPGRADING?
This EAGLE has the latest firmware version available when it was manufactured. However, it is
possible than in the future, new firmware versions will appear adding new features to this codec.
These software versions will be published on AEQ web site:
http:\\www.aeq.es\
PRECAUTIONS BEFORE UPGRADING:
Firmware upgrade process is a delicate process and it is recommended to take some basic
precautions before doing it.
It is strongly recommended to take the EAGLE off the rack, unplugging everything except for
power cable and PC connection cable. The PC should be connected to the same electrical
ground.
In any case, AEQ offers free upgrade.
In case of doubt, contact our Technical Assistance Service: [e-mail]
6.1. SYSTEM CONNECTION
The EAGLE has to be connected to a RS232 port of a PC through RS-232 or RS-422.
If there is more than one EAGLE connected to the E@sy bus, this software will show the
different equipment and its software version. Each one has to be upgraded individually but in
some cases it is possible to run an automatic process.
6.2. INSTALLATION
Run the EagleFu.exe file to install the software:
Follow all the steps until the process is finished.