User`s manual

EAGLE
Multi-Standard Dual-Channel Digital Audio Codec
34
5.3.1.2 SERVER APPLICATION
[e-mail] application is installed in the PC where the codecs are connected.
This application is the interface between the computer network and the control bus where the
E@sy equipment is.
5.3.1.2.1 INSTALLATION
Run the “[e-mail]” application and follow all the steps.
NOTES:
- Installing this software in a PC belonging to an intranet requires supervisor rights over the
computer. In that case, consult your system supervisor.
- The first time this Install Shield Wizard is used, it will ask you to restart the system. If you have
used this wizard before, It won’t be necessary to restart.
5.3.1.2.2 OPERATION:
Once the installation is finished and executed through the icon created in the desktop, the icon
representing it will appear in the task bar:
Clicking over the icon with the mouse right key, ‘SHOW’ option is showed, allowing to see the
program window:
Select the Setup / Port option and configure in the Communications label the port to use.
E@sy equipment have a node number that con be configured for identifying them in a network.
Configure in the Range label the number of nodes that are to be controlled, i.e., how many
E@sy devices are available in the network.
When RANGE is big, process becomes slow. It is recommended to put the minimum range in
order to obtain the best performance. In that case, both leds should be fixed in green.
 Consult the “4.12 Node” chapter to know how to program this number in each equipment.