User`s manual

EAGLE
Multi-Standard Dual-Channel Digital Audio Codec
33
5.3. REMOTE CONTROL SYSTEM
5.3.1. SYSTEM CONNECTION
The EAGLE is controlled through the RS-422 or RS-232 control port.
The EAGLE will be connected to the PC where the E@sy Server is installed through a
connection between serial port and the RS-232 control port.
If using an E@sy equipment network, with more than one E@sy equipment, connection should
be made in parallel.
When all the connections are made, software should be installed as indicated in the following
pages.
If control software is going to be installed in a different PC than the server one, it is necessary to
check that there is an IP connection between both computers. To do that, it is necessary to
know the network name or IP address of the server PC inside the network.
Consult ANNEX A-1 at the end of this manual in order to obtain more information about IP
connections.
Once these steps have been done, It is just necessary to install the applications.