User`s manual

EAGLE
Multi-Standard Dual-Channel Digital Audio Codec
27
4.12. Node.
Identifies the address the equipment occupies on the multi-station control network.
If several units are connected on a network, up to 128, this number must be different from the
numbers on the rest of the units to avoid conflicts on the network.
NODE selection is done in the SETUP section (1) (9).
- On the main screen, press NO (red) to access the SETUP menu.
- With the cursor arrows, go to the NODE option and press OK.
- Key in the desired figure using the number pad (2), and press OK to finish.
4.13. Retrying.
By activating this option, you configure the unit to automatically retry those calls where the
connection was unsuccessful or has been cut off.
 This option has to be activated after the call is connected. If it is activated when no call is
established, the EAGLE will dial the last called number.
4.14. Encoding mode selection.
There is a great variety of encoding modes, previously explained in chapter 1.3. To select a
mode, you must do the following:
This selection is done from the SETUP section (1) (9).
- On the main screen, select the desired channel using the cursor arrows.
- Press OK to access the encoding menu.
- With the cursor arrows, scroll to the desired encoding mode, and press OK to finish.
- Press NO to go back to main screen.
RETRYING
LINE 1
LINE 2
OFF
ON
ON
OFF