User`s manual

EAGLE
Multi-Standard Dual-Channel Digital Audio Codec
19
4.4. Aux telset.
Located on the front panel, the TELSET connector (13) makes it possible to perform two
functions: Remote control and Intercommunication. To do this, it is necessary to connect an
analog, fixed or wireless phone to this connector.
- Intercom. With the telephone equipment connected to the TELSET connector (13) and when
communication is established, the telephone handset replaces the intercom microphone (6) and
its respective headset (14), and intercommunication tasks can be performed through that
telephone.
 Using the auxiliary phone as an intercom disables the intercom incorporated in the equipment.
 Activating the intercom interrupts incoming signal from rear XLR connectors.
- Remote control. When a connection is established, DTMF tones generated in the analog
control phone are used to perform remote control functions. This system is different to the
DTMF tones generation in audio channels (see chapter 4.19).
The control functions and the commands currently available are the following:
∗
∗∗
∗ 1 (telephone no.) ∗
∗∗
∗ Makes a call on line 1 to the phone number dialed.
∗
∗∗
∗2 (telephone no.) ∗
∗∗
∗ Makes a call on line 2 to the phone number dialed.
∗
∗∗
∗ 1 ∗
∗∗
∗ Selects line 1 to make a call on that line. Hangs up a call established on line 1. Takes
a call coming in on line 1 off hook in the OFF HOOK MANUAL mode.
∗
∗∗
∗ 2 ∗
∗∗
∗ Selects line 2 to make a call on that line. Hangs up a call established on line 2. Takes
a call coming in on line 2 off hook in the OFF HOOK MANUAL mode.
∗
∗∗
∗ 3 ∗
∗∗
∗ Recalls the last number dialed on line 1.
∗
∗∗
∗ 4 ∗
∗∗
∗ Recalls the last number dialed on line 2.
# Lets you escape to return to initial status in generating DTMF control commands.
Note: All control commands begin and end with “∗
∗∗
∗”.