User`s manual

EAGLE

Multi-Standard Dual-Channel Digital Audio Codec

4. OPERATION AND USER INTERFACE

4.1. Phone book.

The phone book allows us to store the phone numbers we frequently need to use in our

communications, up to 256. This feature might let us, for example, store all the numbers of a

transmitter’s regional centers.

1.- Create a new entry:

Configuration of the phone book is done in the DIAL section (Front panel, no. 10).

- On the main screen, press the direction arrows located under the DIAL LCD.

This menu will be displayed:

 001 –EMPTY-

002 –EMPTY-

- With the cursor arrows, move up and down until reaching the number of the phone book

position you want to use. Press OK in that position.

This menu will be displayed:

 EDIT

DELETE

- Press OK on the EDIT line. Using the number pad, type the name that will be in this position.

- Press OK and type in the phone number.

- Press OK to complete the process.

2.- Delete an entry:

- With the cursor arrows, move up and down until reaching the number of the phone book

position you want to delete. Press OK in that position.

This menu will be displayed:

 EDIT

DELETE

- Press OK on the DELETE line.

- Press OK to complete the process.

3.- Search for an entry:

A search is performed in the DIAL section (Front panel, no. 10) by pressing the direction arrows

located under the DIAL LCD (middle yellow keys). Thus, we move up or down until we find the

entry selected.

4.- Calling from the phone book:

If the number is stored in the phone book, instead of keying it in, we would press the cursor

arrows until we reach the desired phone book position. Press OK to start the call.

Stored numbers can be read from remote control application.

4.2. Automatic startup.

There are 30 possible automatic startup configurations that can be programmed by the user.

These startup configurations can then be selected through five of the DIP microswitches on the

back of the unit. The user can configure positions C02 to C31.

DIP switches position and number relation can be found in chapter 3.2, section 10.

Position C00 .............. Test mode, used when so instructed by Technical Service

Position C01 ............... Manual startup mode.

Positions C02 to C31 .…. Automatic startup modes.