Specifications

AEOTEC Engineering Specification
9
3 PRODUCT QUICK START
3.1 Important safety information
Please read this Engineering Specification carefully for correct and effective use.
Failure to follow the recommendations set forth by AEOTEC Limited may be dangerous or cause a violation of the law.
The manufacturer, importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting
from not following any instruction in this guide or in other materials.
3.2 How to install the product
Getting your Range Extender up and running is as simple as plugging it into a wall outlet and adding it to your Z-Wave
network.
3.3 How to add the product into Z-Wave network
This product supports Security 2 Command Class. While a Security S2 enabled Controller is needed in order to fully use
the security feature. This product can be included and operated in any Z-Wave network with other Z-Wave certified
devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will
act as repeaters regardless of vendor to increase reliability of the network.
3.3.1 SmartStart Learn Mode
SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the
product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will
be added automatically within 10 minutes after this product being powered on in the network vicinity.
3.3.2 Classic Inclusion Learn Mode
1. Set your Z-Wave Controller into its 'Add Device' mode in order to add the product into your Z-Wave system. Refer to
the Controller's manual if you are unsure of how to perform this step.
2. Make sure the product is powered. If not, plug it into a wall socket and power on; its LED will be breathing white light
all the time.
3. Click Action Button once, it will quickly flash white light for 30 seconds until it is added into the network. It will
become constantly bright white light after being assigned a NodeID.
4. If your Z-Wave Controller supports S2 encryption, enter the first 5 digits of DSK into your Controller's interface if
/when requested. The DSK is printed on its housing.
5. If Adding fails, it will come back to breathing white light; repeat steps 1 to 4. Contact us for further support if needed.
6. If Adding succeeds, it will turn to white light. Now, this product is a part of your Z-Wave home control system. You can
configure it and its automations via your Z-Wave system; please refer to your software's user guide for precise
instructions.
Note:
If Action Button is clicked again during the Classic Inclusion Learn Mode, the Classic Inclusion Learn Mode will exit. At
the same time, Indicator Light will become breathing white light.
3.4 How to remove the product from Z-Wave network
1. Set your Z-Wave Controller into its 'Remove Device' mode in order to remove the product from your Z-Wave system.
Refer to the Controller's manual if you are unsure of how to perform this step.