User Guide

have a controller on hand and you'd like to reset your Water Sensor 6 in preparation for a new controller, follow the steps
below:
1. Press and hold the Action Button of your Water Sensor 6 for 20 seconds.
2. Wait until the RGB LED turns into a green or rainbow gradient Color after 20 seconds of holding.
3. Release the Action Button.
4. If your Water Sensor 6 has been successfully factory reset, the RGB LED will be active with a colorful gradient for 3
seconds before disappearing. When you tap the Action Button on Water Sensor, its green LED will blink rapidly. If
the factory reset was unsuccessful, the green LED will remain on solid for a few seconds when you tap the Action
Button.
Replacing your sensors battery.
Your Water Sensor 6 uses 1x CR123A battery that has a 2 year battery life maximum. Ultimately the battery life of the
sensor will highly depend on the uses and settings of Water Sensor. When battery power has depleted, below are the
steps you can take to replace the battery in your Water Sensor 6.
1. Unscrew the 2 screws from Water Sensor 6. On the rear of Water Sensor 6 you'll find 2 screws in opposing corners.
2. Separate the battery cover from the Sensor unit. Use the separation tool to separate the battery cover by pushing or
moving the separation along the gap between the battery cover and the sensor unit.
Aeotec Water Sensor 6 user guide : Aeotec Help Desk https://help.aeotec.com/support/solutions/articles/6000171886-water-sen...
7 of 9 30/12/2021, 17:52