User Guide

1. From your gateway, enter the configuration settings that you want.
2. Your gateway will wait for Water Sensor to wake up to send the command. Typically your gateway will confirm that
Water Sensor 6 will need to wake up.
3. Tap the Action Button once on Water Sensor, and your gateway will automatically send the configurations to your
Water Sensor 6.
Removing Water Sensor 6 from your Z-Wave Network.
This is the preferred method of removing your Water Sensor 6. Using this method will ensure that Water Sensor does not
leave a phantom/failed node in your network. Sometimes phantom/failed nodes become impossible or difficult to remove.
This method can be used with any Primary Z-Wave Gateway (Water Sensor does not need to be paired for an
unsuccessful pair).
1. Set your Z-Wave gateway into unpair/removal mode.
2. Tap the Action Button once on Water Sensor 6.
3. If it was successful, the RGB LED of your Water Sensor 6 will become a rainbow gradient, and your gateway should
confirm a successful removal.
4. Repeat steps 1-3 if you do not see the rainbow gradient LED.
Testing Health Connectivity.
Note - Health test does not test for routing communication health, only tests for direct communication with your gateway to
determine if it has a healthy direct connection.
You can determine the health of your Water Sensor 6s connectivity to your gateway using a manual button press, hold,
and release function which is indicated by the LED color.
1. Press and hold Water Sensor 6 Action button
2. Wait until the RGB LED turns into a Purple Color
3. Release Water Sensor 6 Action Button
The RGB LED will blink its Purple color while sending ping messages to your gateway, when it has finished, it will blink 1 of
3 colors:
Red = Bad Health
Yellow = Moderate Health
Green = Great Health
Be sure to watch for the blink, as it will only blink once very quickly.
Manual factory reset Water Sensor 6.
We highly suggest using the gateway to remove your Water Sensor 6 from the network, but in the case that you no longer
Aeotec Water Sensor 6 user guide : Aeotec Help Desk https://help.aeotec.com/support/solutions/articles/6000171886-water-sen...
6 of 9 30/12/2021, 17:52