User Guide

Important safety information.
Please read this and other device guides carefully. Failure to follow the recommendations set forth by Aeotec Limited may
be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and /or reseller will not be held
responsible for any loss or damage resulting from not following any instructions in this guide or in other materials.
Keep product and batteries away from open flames and extreme heat. Avoid direct sun light or heat exposure. Always
remove all batteries from products that are being stored and not used. Batteries may damage the appliance if they leak. Do
not use rechargeable batteries. Ensure correct polarity when inserting the batteries. Improper battery use may damage the
product.
To optimally detect water and leaks, Water Sensor 6 is intended for use in dry locations that then become wet.
Contains small parts; keep away from children.
Quick Start.
Power on Water Sensor 6.
Water Sensor 6 ships with its battery pre-installed but disconnected. To connect the battery;
1. Remove the battery tab by pulling it away from water sensor.
2. Press the sensor's Action Button; its LED will blink to indicate that the sensor is powered.
3. Secure Water Sensor 6's water proof cover using the screw provided in the package. On the rear of Water Sensor 6
you'll find 2 screw holes in opposing corners; one screw hole will not contain a screw. Insert the provided screw into
the empty hole and tighten it with a screw driver.
Aeotec Water Sensor 6 user guide : Aeotec Help Desk https://help.aeotec.com/support/solutions/articles/6000171886-water-sen...
2 of 9 30/12/2021, 17:52