Installation Manual

The

AEON-45200 /AEON-45250 includes

a cable

management system

where cable can be routed along

the length of

the arm assembly.

Route the display cable along the entrance of the cable

management slot.(Fig.6)

For optimal performance, route the AC power

cable separately form the signal cables.

With all cables in place, pull the display in and out to

be certain that the arm assembly moves freely, without

stretching or damaging the cables.

Note:

The

AEON-45200 / AEON-45250 provides

a wide range of adjustment possibilities to suit your environment.

RollControl - Horizontal leveling of the flat panel display.

Grasp the edge of the display and roll it up or down into a level position (Fig.7).

Tilt Adjustment - Raising or lowering the screen to improve viewing angle.

Grasp the upper and lower edges of the display, and then turn it to the desired tilt angle(Fig.8).

Fig.9

To lock the tilt angle, tighten the tilt knob (Fig.9) securely.

Fig.7

NOTE: For heavier displays, never fully release the tilt knob without fully

supporting the display.

The tilt lever includes a ratchet function, so that it can be lifted and

repositioned for the next turn. To operate the ratchet, pull the lever

straight out, rotate it to an unobstructed position, release the lever,

and then turn it in the desired direction. Repeat as necessary until

the tilt tension is set properly (Fig.10)

Tilt

Kno

Tilt Knob

Fig.10

U-Cap Cable

management

Cable

Fig.6

Fig.8

Step 4 Using Cable Management

Step 5 Adjusting the Display