Installation Manual

INSTALLATION
INSTALLATION
a
X
TVTV TV TV
5
Attaching the Adapter Plates
Option
A~D
E
(200mm)
spacers
Using Cable Management
8
a
X
TVTV TV TV
7
Attaching the TV to the Mount
Option
A~D
E
200mm
A~D
E
Option
E
Attaching the Adapter Plates to TVs with a Recessed Mounting Pattern
6
NOTE:
This step is necessary for TVs with a 300 x 300
or 400 x 400mm VESA pattern.
1. Place the adapter plates on the back of the
TV (with the slotted mounting holes at the top)
aligning them with the appropriate VESA
pattern. Install the top two screws to secure
the adapter plates to the back of the TV, please
note the adapter plates must be 8” or 200mm
apart from one another so the TV mount
faceplate can be attached them.
8”
1 2 3 4 5 6 7 8 9 10
2. Next, install the top two (2) Bolts and nuts into the adapter plate with the bolt head(s) facing you;
do not completely tighten these yet.
If your TVs mounting holes are recessed
please incorporate the included spacers by
placing them between the back of the TV and
the adapter plates. If not, proceed to step 7.
(200mm)
8”
p.4
p.5
1. Install the bottom two (2)
bolts and nuts in the oppo-
site order of step 5, the
bottom two bolts will have
the bolt heads facing your TV
when installed through the
adapter plates, do not install
the nuts yet.
2. Now install the TV Mount onto the adapter plates by lining up the two slotted holes at the top
of the faceplate and hooking them on to the top two bolts. These can now be securely tightened.
The bottom two bolts will slide through the adapter plate so the nuts can be installed and tight-
ened securely; locking the TV mount in place.
Easy to use cable management allows several cords / interconnects to be concealed putting a
neat, clean appearance on your installation.