Technical data

ManualsBrandsAeon Labs Manualselectrical equipment & suppliesMicro Smart Energy Switch

AEO_MSES

Micro Smart Energy Switch

Firmware Version : 1.41

Quick Start

A This device is a Z-Wave Actuator.

Single click the button located near the Status Indication LED or alternatively press quickly 6 times the external switch/button

control to include or exclude the device. If the Aeon Labs Micro Smart Energy Switch is not included into any Z-Wave network, the

LED will be blinking slowly continually.

Please refer to the chapters below for detailed information about all aspects of the products usage.

Product description

The Aeon Labs Micro Smart Energy Switch is a low-cost Z-Wave appliance switch specifically used to enable Z-Wave command and

control (on/off) for existing in-wall switches. The wireless module is powered from the mains supply and is a three-wire design

which requires a neutral connection. In the event of power failure, non-volatile memory retains all programmed information

relating to the units operating status.

Installation Guidelines

The device is a 3 wire design which requires a neutral connection. The module is powered from the main supply.

The schematics below show how to wire the actuator. The power supply and the appliance are connected by the Load, Power Input

and Neutral connectors. The 3.3 Volt and External Switch connectors are for external switching.

After the electrical installation the device has to be implemented in the Z-Wave Network.

Summary of content (5 pages)

PAGE 1
AEO_MSES Micro Smart Energy Switch Firmware Version : 1.41 Quick Start A This device is a Z-Wave Actuator. Single click the button located near the Status Indication LED or alternatively press quickly 6 times the external switch/button control to include or exclude the device. If the Aeon Labs Micro Smart Energy Switch is not included into any Z-Wave network, the LED will be blinking slowly continually. Please refer to the chapters below for detailed information about all aspects of the products usage.
PAGE 2
Behavior within the Z-Wave network I On factory default the device does not belong to any Z-Wave network. The device needs to join an existing wireless network to communicate with the devices of this network. This process is called Inclusion. Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion mode.
PAGE 3
to user needs or unlock further enhanced features. IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 … 255 the value sent in the application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of 200 minus 256 = minus 56. In case of a two byte value the same logic applies: Values greater than 32768 may needed to be given as negative values too.
PAGE 4
Report type send in Reporting Group 1 (Parameter Number 101, Parameter Size 4) Defines the type of report sent for the Reporting Group 1. Value Description 2 MultiSensor Report 4 Meter Report for Watt 8 Meter Report for kWh (Default) Report Type send in Reporting Group 2 (Parameter Number 102, Parameter Size 4) Defines the type of report sent for the Reporting Group 2.
PAGE 5
Explorer Frame Support No SDK 5.02 pl3 Device Type Slave with routing capabilities Generic Device Class Binary Switch Specific Device Class Binary Power Switch Routing Yes FLiRS No Firmware Version 1.41 5 (c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, www.zwaveeurope.