User Manual

After complete the sec
uring of the Sensor plate, your Water Sensor 6 unit will possess the
high waterproof level of IP65.
Your Water Sensor 6 also can be powered by the Dock, if you want to know more about it,
please refer to the Dock manual.
[Heading 2] Adding your Sensor to your Z-Wave network.[/Heading 2]
With your sensor is powered on, it’s time to add it to your Z-Wave network.
1. Let your Z-Wave primary controller/gateway enter into adding/inclusion mode.
2.
Take your Sensor near to your primary controller.
3.
Press the Action Button once on your Sensor, the green LED will blin
k.
4.
If your Water Sensor 6 has been successfully added to your Z-Wave network, its green LED will
be solid for 2 seconds and then the orange LED will fast blink for 10 minutes if the Sensor does
not receive the Wake Up No More info Command from Controller. If the adding was
unsuccessful and the red LED will be solid for 2 seconds and then become colourful gradient
for a few seconds before it turns off, repeat the above steps.
With your Sensor now working as a part of your smart home, you’ll be able to configure it from
y
our home control software or phone application. Please refer to your software’s user guide for
precise instructions on configuring the Water Sensor 6 to your needs.
[Heading 2]Installing your Water Sensor 6 .[/Heading 2]
The ins
tallation of your Water Sensor 6 is very simple, since you just need to select where you'll
place your Water Sensor 6 in your home to detect whether there is water leakage.
For example, you can put it on the floor or somewhere of your washroom or kitchen and so on. In
case, your washroom’s water pipe is ruptured or the water leakage happens without knowing it.
However, the Water Sensor 6 detected this water leakage event, it sends out the notification
message immediately to tell your home gateway to shut off the main water gate of your home for
avoiding water leakage accident. At the same time, the buzzer keeps playing alarm sounds to tell
the people at home that the water leak is detected.