User Manual

16
17
Set your Z-Wave controller into pairing mode.
Press the Action Button on the Nano Dimmer or
toggle the external manual switch once, the green
LED (non-secure indication) will blink to indicate
the Nano Dimmer is entering into pairing mode.
If the Nano Dimmer has been successfully added
to your Z-Wave network, its RGB LED will be
solid. If the pairing was unsuccessful, the red
LED will be on for 2 seconds and then remain a
colourful gradient, repeat the instructions above
from step 1.
With your Nano Dimmer now working as a part of
your smart home, you’ll be able to congure it from
your home control software/phone application.
4
Removing Nano Dimmer from a
Z-Wave network.
The colour of RGB LED will change according to the
output load power level:
1.
2.
3.
Dimmer to turn it On/Off/Dim directly via pressing
your Nano Dimmer’s Action Button, it is time to add
your Nano Dimmer to the Z-Wave network. To set
your Z-Wave gateway/controller into pairing mode,
please refer to the respective section within your
controller instruction manual.
Please refer to your software’s user guide for further
instructions on configuring Nano Dimmer to your
needs.
Version LED indication Output (W)
US
Green [0W, 48W)
Yellow [48W, 96W)
Red [96W, 144W)
AU
Green [0W, 92W)
Yellow [92W, 184W)
Red [184W, 276W)
EU
Green [0W, 92W)
Yellow [92W, 184W)
Red [184W, 276W)