User Manual

15
18
After your Nano Dimmer is installed and powered
on, you are now able to manually control the Nano
When the Nano Dimmer is powered on, it will
automatically identify the connected load type and
then match it.
3
Adding your Nano Dimmer to a Z-Wave
network.
Quick start.
ON
ON
ON
ON
ON ON
ON
ON
ON
ON
5
Advanced functions.
Changing mode on the External Switch/Button
Control.
Your Nano Dimmer can be removed from your
Z-Wave network at any time. You’ll need to use
your Z-Wave network’s main controller. To set your
Z-Wave controller/gateway into removal mode,
please refer to the respective section within your
controller instruction manual.
Set your Z-Wave controller into removal mode.
Press the Action Button on the Nano Dimmer or
toggle the external manual switch 2 times in fast
succession.
If the Nano Dimmer has been successfully
removed from your Z-Wave network, its RGB
LED will remain colourful gradient. If the removal
was unsuccessful, the RGB LED will still be solid
(following the state of the output load), repeat the
instructions above from step 1.
1.
2.
3.